Trex eCCPM Mod : CCPM

This conversion is for HS56 servos. Other servos can be used but dont drill the 2mm holes in the frames until the servo box is offered in place. Other servos may need to be packed in the servo box to lift them up slightly.

This conversion really is easy to perform and should take no longer than a few hours to finish. The canopy and mounting points do not have to be modified in any way.

Once complete the servo box will be very strong so if you are unlucky enough to crash and break the frames the servo box can be transferred with very little work to the new frames. 

By removing three screws from each side you have easy access to the motor and there is no need to unplug any servos.

Next