Trex eCCPM Mod : Cutting The Frame

Tip. stick masking tape to the area of the frame to be cut. You can then draw on it really easy.

1. Draw cutting lines as shown in pic.
Click here to enlarge the picture below.



2. Mark where the 2mm holes are to be drilled on the frames as in pic.

3. Drill a 5mm hole in the corner (this will prevent a weak spot in the frame).

4. Drill 2mm holes.

5. Cut the frames with a junior hack saw , knife or dremel.

6. File / sand any burs (imperfections) off.

Back Next